![]() ![]() It is of major benefit to listen to 'live' sounds, recall them as best you can, and compare to what your system is providing, and have a few sonically superior reference quality recordings to use to evaluate your system/environment/setup. ![]() Then if your speakers offer any transparency at all, as most dipoles do, then regardless of top end gear, cables, or other tweaks, and with a proper room/speaker/amp match, and setup, any fatiguing, or distastful sonic characteristics are from your source material (the secret ghost of audio confusion). 05, etc.Įxamples: Hafler DH-200, 220 Anthem PVA2/5/7 Rotel ATI Muse 1 $Bryston$ $Jeff Rowlands$. But what is the frequency range, input/output impedance, and damping factor?Ī VERY low distortion amp should also have a frequency range of say 5hz-50khz or more,Īn Output impedance of less than 0.4 ohms,Īn input impdedance greater than 10k ohms,Īs well as a THD of less than 0.1 (those listed below run more like 0.03 to. Posted on Wednesday, Janu23:44 GMTThe specs of the M2A look good as they go.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |